Re: Creo Simulate 2.0 - Rotating Frame of Reference?
This is the deformation that opens up like a flower, not the previous deformation. So which one is correct?
View ArticleRe: Creo Simulate 2.0 - Rotating Frame of Reference?
What did you change, direction of rotation?
View ArticleRe: Creo Simulate 2.0 - Rotating Frame of Reference?
Erick, I'm going to open a new discussion on this, because the original discussion was "rotating frame of reference" which I don't think Creo can do, as in ALGOR for fluid flows through a turbine. The...
View ArticleRe: Creo Simulate 2.0 - Rotating Frame of Reference?
You stated that the turbine should open up like a flower. If I put the load parallel with axis of rotation, this does not happen, as you can see in one of the displacement images. If I put the load...
View ArticleRe: Creo Simulate 2.0 - Rotating Frame of Reference?
Steven My simple example opened up like a flower, because it's obvious where the ineria is with respect to the stiffness.Your Nov 20, 2013 2:13 PM picture is the right one. Rotate about the right...
View ArticleRe: Creo Simulate 2.0 - Rotating Frame of Reference?
Erik, The problem I have with that particular displacement image (Nov 20, 2013 2:13 PM) is that the turbine is compressing in the positive Y direction, where it should be displacing outward in the XZ...
View ArticleRe: Creo Simulate 2.0 - Rotating Frame of Reference?
Can you send me the part, this is taking too much time. Let me look into it, i'll send the correct model back
View ArticleRe: Creo Simulate 2.0 - Rotating Frame of Reference?
Erick, Thanks for helping on this. I think all I need is the constraint and load, and you can just upload the images without sending the model back.
View ArticleRe: Creo Simulate 2.0 - Rotating Frame of Reference?
A presentation on https://drive.google.com/file/d/0BxuTvot6TxcLZS1zeXVtbFd4Wnc/edit?usp=sharing A movie of the resultshttps://drive.google.com/file/d/0BxuTvot6TxcLMGlWRE5fbXRNdnM/edit?usp=sharing I...
View ArticleCreo Simulate 2.0 - Rotating Frame of Reference?
Does Creo Simulate 2.0 have the capability to set up a rotating frame of reference?
View Article
More Pages to Explore .....